- Brand : BETAFPV
- Model : F4 brushed flight controller
- Applicable gender : male
- Aircraft Type : Official Standard Configuration
- Toy Type : Electric Toys
- Color classification : F4 1S brushed flight control
The classic F4 1S brushed flight controller brings new changes and shapes. Built-in CC2500 chip, the factory default protocol configuration is Frsky D8, which can be adjusted to Frsky D16 FCC, Frsky D16 LBT or Futaba. In addition, the power cord adopts BT2.0 connector instead of PH2.0, which improves performance and is compatible with BETAFPV BT2.0 series batteries.
Product Introduction
- CPU: STM32F411CEU6
- Gyroscope: MPU6500
- ESC Peak current: The maximum rated current is 30A
- Motor: Support 6x15mm/7x16mm/8x20mm/8.5x20mm and other motors. Recommended BETAFPV 7x16mm brushed motor (2CW+2CCW)
- Size: 26mm x 26mm, fully compatible with Industrix quad rack and installation mode
- Firmware version: Betaflight BETAFPVF411RX 4.2.11
- OSD: Built-in BetaLight OSD (STM32 controls OSD via SPI in DMA mode Chip)
- Receiver: SPI Frsky D8 (CC2500 chip, adjustable)
- Power cord: 55mm, with BT2.0 connector
- Weight: 3.68g (with power cable)
Comparison with F4 1S Brushed FC V1.2
F4 Brushed Flight Controller V2.0 comes with SPI Frsky D8 receiver, compatible with Futaba S-FHSS, Frsky D16 FCC, Frsky D16 LBT protocols. The power cord adopts BT2.0 connector instead of PH2.0, which solves the problem of voltage sag, and the discharge efficiency is higher, so that the board has better performance in power supply and response performance. What’s more, it is compatible with BETAFPV BT2.0 series batteries, which is convenient for future upgrades. Plus, it supports custom RGB LED lights on Betaflight configurations to make your drone unique.
F4 brushed flight control schematic diagram
The following figure is the F4 brushed flight control schematic diagram
Connection diagram for VTX. This is an example M03 25-350mW 5.8G VTX
The default LED status is as follows. It supports custom RGB LED lights on BetaLight configurations.
The SPI Frsky receiver has
a built-in SPI receiver CC2500 chip, and the F4 brushed FC V2.0 is compatible with Futaba S-FHSS, Frsky D16 FCC and D16 LBT protocols. The default protocol configuration is Frsky D8 at the factory. Pilots can set protocols as desired in the BetaLight Configurator.
Recommended Parts List
Battery: BT2.0 300mAh 1S Battery
Frame: 65mm Frame
Propeller: 31mm 3-blade
Motor: BETAFPV 7x16mm Brushed Motor (2CW+2CCW)
Image Transmission: M03 25-350mW VTX
Recommended Ride: Beta65S BNF Micro Whoop Quadcopter
There are no reviews yet.